Online only

Fall protection parapet for flat slabs and vertical curbs MH 78

Valutazione 

MH78

New product

PISCOPIELLO PONTEGGI

Disponibile

Smart and versatile parapet post, designed for use on flat, inclined or vertical surfaces; it can be configured, according to requirements, in two different ways: fixing on veils and curbs or installation on flat or inclined supports.  TECHNICAL SHEET MH78 MAST

ATTENTION THE ITEM HAS BEEN REPLACED WITH PARAPET MH77

More details

Request product info

More info

This model of parapet upright is characterized by its versatility, in fact it has been designed for multi-purpose use: both on flat surfaces, and on inclined or vertical surfaces.
Depending on the construction site requirement, the bodyguard can be configured in two different ways: in configuration A it can be fixed on vertical supports such as veils and curbs; in configuration B it can be installed on flat or inclined supports (such as slabs, stairs, terraces or balconies). The maximum grip thickness is 52 cm.

montante per parapetto per cordoli e travi

elementi montante parapetto mh18maxi

Montante parapetto - sistema di protezione collettiva Mh18

The MH 78 temporary parapet post consists mainly of two elements.
The 1st element consists of a vertical upright made with a circular tube (1) on which three L-shaped brackets (2) are welded to support the anti-fall boards.
The 2nd element is the clamping vice, designed to be usable on both vertical and horizontal surfaces. Built with square section tubulars, its opening and closing is regulated by a crank (3) connected to a threaded bar: the latter allows the sliding of a 35x35x2 mm tubular (4) inside a housing (5 ) made with a tubular size 40x40x2 mm.
The upper part of the vice (6) is also made with a square section tubular 40x40x2 mm, while the lower part (7) consists of a 'U' fork, on which a plate for fixing the vice is welded .
Two sections of circular tube (8 and 9) are welded to the vice for housing the upright in the two possible configurations. The maximum opening of the vice is 52 cm.

Reference standards and certifications
UNI EN 13374: 2004 standard
Temporary edge protection systems' product specification and test methods.
Legislative Decree No. 81 of April 90, 2008
Protection of health and safety in the workplace.
The parapet has not been tested by any laboratory since being usable for roofs belonging to class A, i.e. for slopes less than 10 ° (equal to a slope of 18%), a project drawn up by an engineer is sufficient enabled and there is no obligation to carry out laboratory tests in accordance with point 5.2.1 of UNI EN 13374 standards.

Parapet Technical Sheet

Useful Height

200 cm

Maximum distance from the facade of the building

-

Riser tube

40x2.0 mm

Support tube

-

Parapet weight

7.2 kg

Certification

class A according to EN 13374: 2013

Center distance of the uprights

120 cm

Threaded rodM14
Section anchor plate-
Section support plate

-

Reviews

Grade 
12/11/2020

PARAPETTO

Parappetto molto forte e sicuro, spedizione ottima.

    Write a review

    Fall protection parapet for flat slabs and vertical curbs MH 78

    Fall protection parapet for flat slabs and vertical curbs MH 78

    Smart and versatile parapet post, designed for use on flat, inclined or vertical surfaces; it can be configured, according to requirements, in two different ways: fixing on veils and curbs or installation on flat or inclined supports.  TECHNICAL SHEET MH78 MAST

    ATTENTION THE ITEM HAS BEEN REPLACED WITH PARAPET MH77

    20 other products in the same category:

    Viewed products

    Top sellers

    Specials

    Follow us on Facebook